Steel Take Up Machine

The first Safety precautions for  LZ600 wire drawing machine+spool take up machine 1. 1 Professional and technical personnel are required to carry out installation and commissioning. Before use, it is necessary to carefully read this manual and the relevant electrical instructions provided.1. 2 Each machine and electric control cabinet shall be reliably grounded with a grounding resistance not more than 4Ω.1. 3 There should be no accumulated water on the table top, especially near the operation box, as it can easily lead to circuit failure due to water infiltration.1.4 It is prohibited for multiple people to operate the same equipment at the same time to avoid accidents.1. 5 The electric control cabinet should be placed in a clean and dry room, and the door should be closed when working to prevent dust intrusion from causing device performance degradation or failure. Air conditioning is used to maintain the ambient temperature of the electric control cabinet. Frequently check the operation of the cooling fan on the top of the electric control cabinet.1. 6 Before starting the machine, check whether the safety device is normal.1. 7 Do not operate the components in the electrical cabinet with power. After cutting off the main power supply, wait at least five minutes, and wait until the intermediate circuit capacitance is discharged before operating the frequency converter, motor, or motor cable.1.8 Do not touch the IC circuits on the inverter control interface board and motor control board, as static electricity may damage these circuits.1.9 Please provide the power supply and operating environment according to the technical requirements of Section 3.2. It is not allowed to arbitrarily change the parameters of the frequency converter and PLC. The user shall be responsible for any damage to electrical components caused by human factors.The second Delivery inspection2. 1. Check whether the equipment is damaged and complete upon delivery (according to the packing list). If there is any damage or inconsistency with the contract, please contact the dealer or manufacturer immediately.2. 2 The manufacturer is only responsible for quality issues arising during production, and is not responsible for damage caused during unpacking, improper installation and use, or damage caused by overload operation.2. 3 After unpacking, the accompanying documents should be properly kept, as they are necessary during equipment installation, commissioning, and use.mcThe third technical indicatorsWe can make take up machine,wire drawing machine,layer winding machine,drum packing machine,flux cored forming machine